Edgebanding thickness: .5 – 3 mm
Work piece height: 5/8” to 1-7/8”
Working temperature: 120º - 160º C
Quick preheating: Up to 170º C
Preheating time: 8 – 9 minutes
Feed speed: 11 ft. /min.
Glue pot capacity: 270g
Height: 7.1”
Width of machine: 11”
Length of machine: 12.6”
Weight: 20 lbs.
Total Power: 765W
In-stock
sales of new items from the JGW Co. warehouse are subject to incoming and
outgoing freight charges. FOB: Shipping Point DELIVERY: Immediate Subject
to Prior Sale TERMS: Payment with order. Minimum of a $125.00 Crating Fee if
needed. Prices are subject to change without notice. Used equipment is sold
as is, where is, unless otherwise specified. SELLER EXPRESSLY DISCLAIMS ANY
IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR PURPOSE. Freight, rigging,
and installation are not included unless otherwise specified, but arrangements
can be made at an additional cost. We reserve the right to correct clerical
or specification errors at anytime. All figures USD unless otherwise noted.
ATFS=As Taken From Service.
Machine will apply edgebanding to straight and contour panels
Operates as hand held or bench mounted
Comes with mounting plate for bench top use
Automatic feeding of edgebanding material
Applies wood veneer, PVC, HPL & melamine from .5 to 3mm
Glue Pot with six (6) heating elements and three (3) thermostats for consistent temperature control
270g glue pot allows for comfortable edgebanding of large panels without running out of glue
Glue roller is equipped with guiding wires to keep thin type from wrapping around glue rollers
Removable pressing plate for easy cleaning
Two (2) height adjusters to keep tape straight for precise application of edgebanding
90º angle between pressing roller and guiding plate are setup by two (2) bolts to ensure accuracy
Thickness of panels is setup by guiding plate during manual operation. Standard panel thickness are marked by lines for easy adjustment
Guiding plate can be set at 10º angle for beveled edgebanding
Made with solid European construction
Recommend Jowat 28220 edgebanding adhesives
Portability of MANUAL PLUS allows comfortable edge banding at the workshop.
The Adamik Manual Plus can be changed into a table machine with very little effort.
Optional Equipment or Accessories
Manual Vacuum Clamps - $169.00
The manual vacuum clamps are designed to hold non-porous work pieces. Will keep parts at a height of 10” for easier maneuvering of machine. Uses manual suction cups with quick release.
Power Vacuum Clamp - $400.00
The power vacuum clamps are designed to hold non-porous work pieces using compressed air. Will keep parts at a height of 10” for easier maneuvering of machine. Has 1 cfm@ 80 psi of holding power.
PVC Trim Router - $425.00
The 3310 PVC trim router has a unique cutting bit specifically designed for this tool. It will enable you to trim edging without steps or gouging. (One bit included) Bits are available for 1mm, 2mm or 3mm PVC. Ideal for trimming irregular shaped panels.
Trimming Knife-Straight - $15.00
Compact edge trimming knife for PVC or veneer up to .025” thick. This knife can trim in one direction and has replacement blades which can be purchased in sets of 10.
Trimming Knife-Curved - $15.00
Compact edge trimming knife for PVC and veneer up to .025 thick. This knife can trim in one direction for curved surfaces.
