Polymac Edgebander (I-1-134)

FOB: Shipping Point DELIVERY: Immediate Subject to Prior Sale TERMS: Payment with order.Minimum of a $125.00 Crating Fee if needed. Prices are subject to change without notice. Used equipment is sold as is, where is, unless otherwise specified. SELLER EXPRESSLY DISCLAIMS ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR PURPOSE. Freight, rigging, and installation are not included unless otherwise specified, but arrangements can be made at an additional cost. We reserve the right to correct clerical or specification errors at anytime. All figures USD unless otherwise noted. ATFS=As Taken From Service.

Ergho 5 1998, Serial 80152 220V, 3PH
5/8" edgebanding thickness capacity
Minimum Panel Width 3 3/8"
Minimum Panel Length 6 3/8"
Maximum Panel Thickness 1 3/4"
Automatic strip and coil feed magazine
with 3mm PVC guillotine
Teflon coated Hot Melt glue pot with dual digital thermostats
4 Roll pressure section, with horizontal adjustment and digital indicator
Front and Rear end trim motors, .5HP,
Motors tilt 0-12 degrees
Top and Bottom flush trim motors,
1HP, digital readouts

Top and Bottom Fine/bevel/profile trim motors, .5HP, Motors tilt 0-30 degrees, cutters tilt for 10 degree bevel and 3mm radius round, digital readouts
Open space for additional work station
Top and Bottom scrapers for 3mm thick PVC banding, pneumatic pressure control for scraping knives, digital readouts
Top and Bottom PVC edge reactivation units, Leister hot air blowers with temperature adjustment
Top and Bottom Buffing motors, .5HP, Units