SCMI Selecta 20-F (I-1-135) (W)

FOB: Shipping Point
DELIVERY: Immediate Subject to Prior Sale TERMS: Payment with order. Minimum of a $125.00 Crating Fee if needed.
Prices are subject to change without notice.
Used equipment is sold as is, where is, unless otherwise specified.
SELLER EXPRESSLY DISCLAIMS ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR PURPOSE. Freight, rigging, and installation are not included unless otherwise specified, but arrangements can be made at an additional cost. We reserve the right to correct clerical or specification errors at anytime. All figures USD unless otherwise noted. ATFS=As Taken From Service.

1997 Very good Condition
240V, 3PH Motors
3/4" edgebanding thickness capacity
2 3/8" Minimum panel width, 5 1/2 Minimum Panel Length
Automatic strip and coil feed magazine
4mm PVC guillotine
Teflon Coated Glue Pot
5 roller pressure section
Fron and Rear End Trim motors, .75HP ea.
Motors tilt 0-15 degrees on horizontal plane
Top and Bottom flush/bevel trim motors, 2.5HP ea., Motors bevel from 0-45 degrees with digital readouts
Top and Bottom bevel and raius trim motors, 2.5HP ea., motors bevel 0-45 degrees with digital readouts

Top and Bottom PVC scrapers for up to 3mm radius, pnuematic pressure controlled, with digital readouts
Top and Bottom buffing motors, .4HP ea., units tilt 0-30 degrees
Top and Bottom PVC edge reactivation unit, has Leister hot air blower with temperature adjustment
Rubber pad feed chain with feed speeds of 33 or 66 FPM run by 3HP motor
Insulated safety and sound enclosure
Heated infeed fence
Rotating operator control panel
Telescopic panel support